
EEHA - OVERHAUL AND REPAIR
Learn the skills and knowledge required to overhaul Explosion protected equipment
EEHA Overhaul and Repair Training Course Outline:
This course covers the explosion-protection aspects of overhauling and repairing explosion-protected equipment and the activities required of the responsible person and operative. This skill set will enable the learner to establish and document the level of work required, arrange for work to be carried out, verify compliance, and complete necessary documentation in alignment with the requirements of relevant AS/NZS Standards.
​
EEHA Overhaul and Repair Course Content:
-
Statutory Compliance
-
Roles and Responsibilities
-
AS/NZS 3800
-
Explosion protection principles
-
Explosive atmospheres
-
Overhaul of explosion-protected electrical equipment
-
Repair of explosion-protected electrical equipment
​​
Competencies include:
​
Depending on the requirements of your Certified Workshop, competencies available for AS3800 Overhaul and Repair Short course are:
​
-
UEEHA0004 - Determine the explosion-protection requirements to meet a specified classified hazardous area
-
UEEHA0004 - Enter a classified hazardous area to undertake work related to electrical equipment
-
UEEHA0010 - Supervise repair and overhaul of explosion-protected equipment type Group III ('to)
-
UEEHA0011 - Supervise repair and overhaul of explosion-protected equipment type flameproof (Ex d)
-
UEEHA0012 - Supervise repair and overhaul of explosion-protected equipment type increased safety (Ex e)
-
UEEHA0013 - Supervise repair and overhaul of explosion-protected equipment type intrinsically safe (Ex i)
-
UEEHA0014 - Supervise repair and overhaul of explosion-protected equipment type pressurised (Ex p)
-
UEEHA0015 - Supervise repair and overhaul of explosion-protected rotating machinesSupervise repair and overhaul of explosion-protected rotating machine
​​
Who Should Attend?
The EEHA – Overhaul and Repair specialised skill set is suitable for overhaul & repair workshop supervisors/compliance managers who are required to perform the duties of the responsible/competent person as describes in AS/NZS 3800 and have the following duties:
-
Preparation for overhaul/repair of equipment
-
Establishing the level of overhaul required
-
Arranging the overhaul/repair work
-
Verification that the equipment complies with original certification after work has been completed Documentation of the overhaul/repair work
​​
Refresher Training
AS/NZS 3800 recommends refresher training at intervals not exceeding 3 years
​
​